Car Wont Start After Replacing Crankshaft Sensor

Car Wont Start After Replacing Crankshaft Sensor. What will a bad crankshaft position sensor do. Remove the ckp sensor bolt.

Wont start P0335 Crankshaft Position sensor error North American from www.northamericanmotoring.com

I replaced the crankshaft position sensor under the transmission case, and it got rid of the issue this crank sensor is a common cause of the cherokees , it could no longer read the speed of the crankteeth. Also check for timing chain strech. To confirm your hypothesis, read the dtc codes recorded in the pcm with an obdii scan tool.

Source: www.youtube.com

You should change the crankshaft sensor and camshaft sensor together. 5.3 check and clean all connections and fuses;

Source: www.northamericanmotoring.com

Remove the sensor plug of the crankshaft position sensor. Once you suspect your car might suffer from a faulty ckp sensor, the quickest way to confirm it is to scan your car for codes.

I Am Having A Hrad Time Determining What Is The Issue With My Car After Replacing The Distributor And Ignition Control Module It Still Will Not Hold A Chrage For Longer Than Ten Minutes.

You should change the crankshaft sensor and camshaft sensor together. And can't get a reading the car is still running hence the shutdown, also you will find it also controls the pcm to engage your second fan on the radiator because it cant tell the. Remove the sensor plug of the crankshaft position sensor.

You Will See A Matching Finger On The Engine Block Where The Wheel Mounts That Matches The Groove On The Wheel.

You need further testing done. Would the car start before changing the crankshaft position sensor? This will help the engine ignite, and you'll be able to drive to a mechanic.

I Have The Same Problem Junior Tt Had.

Unplug the sensor and see if it starts. It is not uncommon for these rings to sustain damage to their teeth. If not the crank sensor is bad.

5.2 Use A Jump Starter Or Battery Booster Pack;

If there's plenty of fuel in the tank, turn the ignition, and your engine should start. After that it should start normally. Won't start after replacing distributor and ignition control module.

Cruise At This Speed For As Long As 10 Minutes.

Up to $8 cash back if you disconnected the battery before replacing the sensor, this could be one cause of the vehicle not to start. At part throttle, accelerate your car to 55 mph. (engine will take more cranking without it but should run)