Concrete Thickness For Car Lift
Concrete Thickness For Car Lift. The companies i've talked to said 4 slab of at least 3000psi concrete (thats nothing special) so basically any existing floor. This will provide a more solid base and reduce.
Discussion starter · #1 ·. Maybe dig em down to be 8 thick in that area for a 3x3 area. The ideal thickness is about 140 mm if you are putting up a new slab.
I Would Think With A Good Concrete Mix, 6X6 Ww Mesh, A 4 Thick Slab Should Handle A 4000 Pound Car On A Four Post Lift.
Discussion starter · #1 ·. Build a pad for each post. The height/thickness of the concrete floor depends on the maximum weight the lift can carry.
These Specifications Are Sufficient, But One Critical Factor Is That The Lags Must Be In Full Contact With The Concrete, So 6, At Least In The Area That The Columns Will Set, Is A Good Call.
Slab thickness needed for car lift. Joined jan 22, 2015 · 3 posts. Minimum thickness of four inches for 8,500 lbs ー10,000 lbs (3856 kg ー4356 kg) lifts.
The Existing Slab Was 2500 Psi Concrete, 4.5 Thick, With No Rebar.
How thick is concrete for a car lift? But if your pouring a new slab i'd maybe look into digging the arera where you want the lift posts deeper. For safety both our 2 post hoists and 4 post hoists require a minimum concrete thickness of 150mm at 32mpa as recommended by the manufacturer.
If You’re Planning On Installing A Car Hoist In An Existing Shed, Garage Or Workshop The First Thing You Will Need To Do Is Check That Your Concrete Specifications Are Adequate.
This is a video showing how to reinforce concrete below a 7000 lb car lift. Then that leave youi soem wiggle room on the post mounting the amount of. Pour to concrete additions approx 1 meter by 1 meter by at least 800mm deep.
The Minimum And Recommended Thicknesses Of Concrete Slab For Car Hoists Garage Equipment’s Two And Four Post Hoists Require A Minimum Of 100Mm (About 4”) Of Reinforced Concrete Slab To Be Safely Installed.
The concrete that you pour should be ideally 30mpa strength, in this case, you in fact would not require reinforcing with steel mesh as long as your concrete strength is in the vicinity of 30mpa. The ideal thickness is about 140 mm if you are putting up a new slab. The companies i've talked to said 4 slab of at least 3000psi concrete (thats nothing special) so basically any existing floor.
Post a Comment for "Concrete Thickness For Car Lift"