Adjusting Governor On Club Car - carjpgh
Skip to content Skip to sidebar Skip to footer

Adjusting Governor On Club Car

Adjusting Governor On Club Car. Now, look for the screw that is on the carb that will move the butterfly. Herein, how does club car governor work?

Club Car Golf Cart Governor Adjustment Golf Cart HD Images
Club Car Golf Cart Governor Adjustment Golf Cart HD Images from golf-carts.co

While using club car for carrying 3 to 4 passengers, heavy loads on rough terrain, a more. Now, look for the screw that is on the carb that will move the butterfly. Make sure to use the appropriate screwdriver to remove them from the panel.

Steps To Adjust Club Car Golf Cart Governor.


Up to 15% cash back th e governor is preset and changing this can cause permenant damage to yourr engine as it is only designed to run at a certain rpm. Club car ds throttle cable adjustment. The first step in adjusting the governor is locating it.

To Remove The Governor On A.


View 1 photos for 3651 governors club blvd, columbus, oh 43219 a 2 bed, 2 bath, 1,033 sq. If you change the governor, the same amount of fuel is going to be supplied as before and then you will not have the proper air, fuel mix to make machine run properly. 3701 governors club blvd #2608lpd is located in somerset, columbus.

Screw It In Or Out Till The Carb Is Just Closed In A Relaxed Position.


If the club car has a clutch or throttle cable, then the governor is located there. You could uncover details about the owners and 217 past and present residents. If this rod is found, the governor can be adjusted by simply tightening or loosening the nut attached to the small wire connected to the rod.

After Setting The Golf Cart To Neutral And Maintenance Mode, Jack Up The Rear.


Ensure that the carburetor throttle opens and closes completely when the pedal moves. 3701 governors club blvd #2608lpd, columbus, oh 43219 is a 1 bedroom, 1 bathroom, 678 sqft apartment. This property is not currently available for sale.

Look Behind The Governor To Find A Small Metal Rod That’s Permanently Attached To The Club Car And Stretch Your Rubber Band Enough To Connect It To That Metal Rod.


Loosen the 10mm nut on the throttle cable. Now, start bringing cable out of the box till it just starts to move the butterfly. By mechanically pulling the throttle lever back, you decrease the gas flow to the engine and control the golf cart's speed.

Post a Comment for "Adjusting Governor On Club Car"