Car Idles Fine But Dies When Given Gas

Car Idles Fine But Dies When Given Gas. Very well could be a mass air flow problem sometimes some crud can get on the sensor and cause issues. It sounds like you have a blow off valve that is vented to the atmosphere.

89 high idle dies as soon as u touch to gas pedal Toyota Nation Forum from www.toyotanation.com

If you can get a sample of the fuel after the fuel filter and put that sample in a glass jar, see what the fuel looks like, if it is gray or black, then motor oil is leaking from the high pressure oil system passed the injector o rings and getting into the. Answered in 9 minutes by: When your car is idle, the idle air control valve (iac) controls the fuel mixture.

Source: www.toyotanation.com

The car drove fine until one day then it starts spitting and sputtering when i gas on it when i give it a gas i can get it to hold a idle in drive and go but around the block a couple of times it dies at a stop and doesnt want to start again, its a good thing their is a slope to my drive way the damm thing worked fine when i pulled it and now im just cussing it out thanks for all the ideas the first. First i have a 1991 eagle talon tsi awd that i bought for 1500 and it has a few mods but im not sure on all of them.

Source: fourwheeltrends.com

2001 sentra motor idles but dies as soon as you give it gas i would check the mass airflow sensor, if not working properly it will not have the car adjust to the air coming in causing too much air for fuel causing the engine to die. If the mass airflow sensor is bad, the car should.

You Said You Replaced The Fuel Filter.

If the mass airflow sensor is bad, the car should. When a carburetor becomes faulty, it gums up. Idles fine but dies when given gas.

When You Put In Drive, Reverse Or L, It Will Idle For A Few Seconds Then Begin Stalling Then Stall Out.

When your car is idle, the idle air control valve (iac) controls the fuel mixture. If the boat idles fine and revs fine in neutral in the water and idles fine on the trailer, however has no power when you stick it into drive and give it some throttle. The process of cleaning a carburetor is simple:

The Holes Are Usually On The Bottom Side Of The Tube Where You Cannot Easily See Them.

Ask your own car question. It is located on the clutch lever it is the top wire that is. If thats all ok then its the map sensor manifiold absulte pressure.

Advanced Search Cancel Login / Join.

Got a new transmission in it now. Idles perfectly, no codes in computer. It sounds like you have a blow off valve that is vented to the atmosphere.

But All Of The Sudden, It Wants To Die If You Give It Any Throttle.

It’s connected to the throttle body — part of the air intake system controlling the air flowing into the engine (in response to your gas pedal input). Idle the motor for a while,shut it off then check the oil level, if you see any bubbles in the oil on the dipstick, the oil is no good. It is constantly a estimable mind to adjust the carburetor settings at this prison term.